本文通过乙酸锂与二氧化钛反应，采用一步高温固相法在不同反应温度（750 °C/800 °C/850 °C）和反应气氛（氮气/空气）下合成Li4Ti5O12材料. 通过热重分析、X射线衍射、扫描电子显微镜、循环伏安曲线和充放电曲线分析了Li4Ti5O12的晶体结构，观察其微观形貌，并测试其电化学性能. 结果表明，800 °C氮气烧结得到的Li4Ti5O12（L-800N）材料粒径较小，该材料在1.0C倍率下的首周期放电比容量达到170.7 mAh·g-1，100周期循环后的容量保持率高达94.6%，即使是10C高倍率其首周期放电容量依然有143.0 mAh·g-1，表现出了良好的倍率和循环寿命性能.
Series of spinel lithium titanate (Li4Ti5O12) materials were synthesized by one-step solid-state reaction using lithium acetate and TiO2 as raw materials under different temperatures (750/800/850 °C) and atmospheres (N2/air). The as-prepared Li4Ti5O12 materials were investigated by thermogravimetric analysis, X-ray diffraction, scanning electron microscopy, cyclic voltammotry and charge-discharge test to analyze their crystal structures, microstructures and electrochemical performances. The results show that the Li4Ti5O12（L-800N）material obtained at 800 °C under nitrogen atmosphere exhibited better electrochemical performance and smaller particle size. The initial discharge specific capacity of the optimized Li4Ti5O12 reached 170.7 mAh·g-1 at 1.0C with the capacity retention of 94.6% after 100 cycles. Even at the current density of 10C, the initial discharge specific capacity of 143.0 mAh·g-1 could be achieved, which demonstrated good high-rate and cycling performances.
[1] Wang Y F(王怡菲), Tang Y F(唐宇峰), Qiu Z(仇征), et al. Preparation and electrochemical behavior of Li4Ti5O12 nanosheets as anode material for lithium ion battery[J]. Journal of Electrochemistry(电化学), 2010, 16(1): 46-50.
[2] Ge H, Chen L, Lin S, et al. Advanced electrochemical performances of Li4Ti5O12/Ag prepared by a facile synthesis route[J]. Ionics, 2014, 20(8): 1-4.
[3] Chen Y M, Li X Y, Zhou X Y, et al. Hollow-tunneled graphitic carbon nanofibers through Ni-diffusion-induced graphitization as high-performance anode materials[J]. Energy & Environmental Science, 2014, 7: 2689-2696.
[4] Li X L(李学良), Zhang Y(张杨), You Y H(尤亚华), et al. Ionothermal synthesis and electrochemical properties of Li4Ti5O12 anode material[J]. Journal of the Chinese Ceramic Society(硅酸盐学报), 2013, 1(41): 3-7.
[5] Lin C C, Wu H C, Pan J P, et al. Investigation on suppressed thermal runaway of Li-ion battery by hyper-branched polymer coated on cathode[J]. Electrochimica Acta, 2013, 101: 11-17.
[6] Lin C F, Ding B, Xin Y L, et al. Advanced electrochemical performance of Li4Ti5O12-based materials for lithium-ion battery: Synergistic effect of doping and compositing[J]. Journal of Power Sources, 2014, 248: 1034-1041.
[7] Pang W K, Peterson V K, Sharma N, et al. Lithium migration in Li4Ti5O12 studied using in-situ neutron powder diffraction[J]. Chemistry of Materials, 2014, 26 (7):2318-2326.
[8] Fan L Z, Ni H. Structure design and doping modification of Li4Ti5O12 for lithium ion batteries[C]//Meeting Abstracts. The Electrochemical Society, 2014, 2: 281-281.
[9] Zhang Y L(张永龙), Hu X B(胡学步), Xu Y L(徐云兰), et al. Recent progress of Li4Ti5O12 with different morphologies as anode material[J]. Acta Chimica Sinica(化学学报), 2013, 71(10): 1341-1353.
[10] Wang Y S(王雁生), Wang X Y(王先友), An H F(安红芳), et al. Preparation and electrochemical properties of spinel Li4Ti5O12 by hydrothermal method[J]. The Chinese Journal of Nonferrous Metals(中国有色金属学报), 2010, 20(12): 2366-2371.
[11] Wang Y(王英), Tang R H(唐仁衡), Xiao F M(肖方明), et al. Study on property of anode material Li4Ti5O12 for lithium ion batteries[J]. Materials Research and Application(材料研究与应用), 2011, 5(4): 258-262.
[12] Liu X F, Tong S F, Dai C G, et al. Synthesis of quasi-spherical micro-size lithium titanium oxide by an easy sol-gel method[J]. Journal of Solid State Electrochemistry, 2014: 1-7.
[13] Judd M D, Plunkett B A, Pope M I. The thermal decomposition of calcium, sodium, silver and copper(II) acetates[J]. Journal of Thermal Analysis, 1974, 6(5): 555-563.
[14] Wang L, Zhang Z L, Liang G C, et al. Synthesis and electrochemical performance of Li4Ti5O12/C composite by a starch sol assisted method[J]. Powder Technology, 2012, 215-216: 79-84.
[15] Yang L X, Gao L J. Li4Ti5O12/C composite electrode material synthesized involving conductive carbon precursor for Li-ion battery[J]. Journal of Alloys and Compounds, 2009, 485(1/2): 93-97.
[16] Gao L(高玲), Chou W H(仇卫华), Zhao H L(赵海雷). Lithiated titanium complex oxide as negative electrode[J]. Journal of University of Science and Technology Beijing (北京科技大学学报), 2005, 27(1): 82-85.
[17] Abe Y, Matsui E, Senna M. Preparation of phase pure and well-crystallized Li4Ti5O12 nanoparticles by precision control of starting mixture and calcining at lowest possible temperatures[J]. Journal of Physics and Chemistry of Solids, 2007, 68(5): 681-686.
[18] Han S W, Jeong J, Yoon D H. Effects of high-energy milling on the solid-state synthesis of pure nano-sized Li4Ti5O12 for high power lithium battery applications[J]. Applied Physics A, 2014, 114(3): 925-930.
[19] Yuan T, Cai R, Shao Z P. Different effect of the atmospheres on the phase formation and performance of Li4Ti5O12 prepared from ball-milling-assisted solid-phase reaction with pristine and carbon-precoated TiO2 as starting materials[J]. The Journal of Physical Chemistry C, 2011, 115(11): 4943-4952.
[20] Chiu C X(邱彩霞), Yuan Z Z(袁中直), Liu L(刘玲), et al. Preparation and characterization of Ce4+-doping Li4Ti5O12 anode material for Li-ion battery at its electrochemical properties[J]. Jourmal of Inorganic Materials(无机材料学报), 2013, 28(7): 727-732.
[21] Chen X M, Guan X F, Li L P, et al. Defective mesoporous Li4Ti5O12: An advanced anode material with anomalous capacity and cycling stability at a high rate of 20C[J]. Journal of Power Sources, 2012, 210: 297-302.
[22] Luo J Y, Chen L J, Zhao Y J, et al. The effect of oxygen vacancies on the structure and electrochemistry of LiTi2(PO4)3 for lithium-ion batteries: A combined experimental and theoretical study[J]. Journal of Power Sources, 2009, 194(2): 1075-1080.
