欢迎访问《电化学(中英文)》期刊官方网站,今天是 分享到:

电化学(中英文) ›› 2018, Vol. 24 ›› Issue (2): 154-159.  doi: 10.13208/j.electrochem.170406

• 研究论文 • 上一篇    下一篇

基于铁氰化钾电子媒介体及醛基吡啶盐的电化学免疫传感器

胡霞,申有名,沈广宇*   

  1. 湖南文理学院化学与材料工程学院,湖南 常德,415000
  • 收稿日期:2017-04-06 修回日期:2017-06-16 出版日期:2018-04-28 发布日期:2017-06-16
  • 通讯作者: 沈广宇 E-mail:sgyrab@163.com
  • 基金资助:
    湖南省自然科学基金项目(No. 2016JJ6105)资助

A Label-free Immunosensor Based on K3[Fe(CN)6] and Aldehyde-Functionalized Pyridinium

HU Xia, SHEN You-ming, SHEN Guang-yu*   

  1. College of Chemistry and Material Engineering, Hunan University of Arts and Science, Changde 415000, Hunan,China
  • Received:2017-04-06 Revised:2017-06-16 Published:2018-04-28 Online:2017-06-16
  • Contact: SHEN Guang-yu E-mail:sgyrab@163.com

摘要: 采用聚二烯丙基二甲基氯化铵(PDDA)将铁氰化钾电子媒介体固定在电极表面,构建免标记的电化学免疫传感器. 醛基吡啶盐不仅作为基底物质直接固定抗体,还可以很好地增强电极表面的导电性能. 将构建的传感器用于肿瘤标志物甲胎蛋白的检测. 其线性范围为0.01-20 ng·mL-1,检测下限为0.004 ng·mL-1(3 S/N). 此传感器的构建简单方便、无标记、特异性好,为甲胎蛋白及其他肿瘤标志物提供了新的检测方法.

关键词: 电化学免疫传感器, K3[Fe(CN)6], 醛基吡啶盐, 甲胎蛋白

Abstract: A novel aldehyde-functionalized pyridinium was successfully synthesized. Using K3[Fe(CN)6] as a redox species modified on the surface of the electrode through Poly(diallyldimethylammonium chloride), we developed a label-free immunosensor based on aldehyde-functionalized pyridinium that was applied to simplify antibody immobilization on the electrode surface, in which no additional chemical cross-linking was required. In addition, the introduction of K3[Fe(CN)6] on the surface of electrode avoided the use of other redox species in the electrolyte solution. Under the optimal experimental conditions, differential pulse voltammetry (DPV) signals corresponding to different α-Fetoprotein (AFP) concentrations were measured. After antigens with different concentrations reacted with antibodies immobilized on the electrode surface, the peak current of DPV gradually decreased with increasing concentrations of AFP. The calibration curve showed a good linear relation in the range from 0.01 to 20 ng·mL-1 with the linear regression equation of y = -3.23x + 22.42 (R2=0.9943). The detection limit is 0.004 ng·mL-1 based on a signal-to-noise ratio of 3. The constructed immunosensor is simple, label-free and specific, thus, provides a good diagnostic tool for detection of α-Fetoprotein and other cancer markers.

Key words: electrochemical immunosensor, K3[Fe(CN)6], aldehyde-functionalized pyridinium, α-Fetoprotein

中图分类号: